MP series FAQ TOP
Principle of Electromagnetic Rotation Detector
Outer Dimension (PDF)
Product Brochures (PDF)
MP series FAQs
MP-900 series tightening torque
MP-209 Output voltage characteristics
What is "duty cycle (duty ratio)" of an output signal?
How much capacity should a capacitor have to take a countermeasure against noise?
What is the relationship between a detection gear for the MP-900 series and an output waveform? (Excluding MP-981 and AP-981)
Recommended gear for detecting with the MP-900 series
Can two directly attaching cables of the MP-992 be reinforced?
What are the specifications and outer dimensions of the MP-001 detection gear?
The operation principle of the MP-981 Magneto-electric rotation detector
Why the duty ratio of the MP-981 Magneto-electric rotation detector changes?
Mounting method of the MP-981
About output cable for MP-981
How to branch the signal of the MP-981 Magneto-electric rotation detector
What is the relationship between the shape and the output signal waveform of the detection gear teeth
How to input the signal from the MP-981 into the PLC
Note on mounting several MP-981 units
Is it possible to detect rotation pulse by a hole on a 300Φ shaft which is 30Φ and 50mm depth? (The axis is mode by iron-based material.)
How much impedance can be loaded on MP-981?
Copyright © ONO SOKKI CO.,LTD All Rights Reserved.
Copyright © ONO SOKKI CO.,LTD All Rights Reserved. |