menu

This product is discontinued /
Replaced by CF-4700 FFT Comparator (Click here)

FFT Analyzer FAQs (CF-4500)

I want to judge two trace lines in different orders of tracking result respectively by shape comparator. Can I use INPUT RELAY?(2015.12.01)
How to store or reset the setting condition of the CF-4500, or copy to another unit?(2015.11.02)
How to judge if it exceeds the Upper limit or drops below the Lower limit in the NG judgment when the judgment result is "NG" because of out-of-range of the upper or lower limit?(2015.10.01)
How long does it take to load the panel condition? (1)(2015.10.01)
Is there any state which shows the completion of the loading of panel condition? (2)(2015.10.01)
How long does it take to output the judgment results after the measurement (average processing)? (3)(2015.10.01)
The judgment block differs depending on the target object. Is it possible to change the judgment block without switching the panel condition? (4)(2015.10.01)
Is it possible to have a hardcopy of the screen of the CF-4500? (5)(2015.10.01)
Is there any recommended USB memory? (6)(2015.10.01)
What kind of communication command can be registered to the input contact? (7)(2015.10.01)
Is it possible to set AND or OR to each block when several judgment blocks are set? (8)(2015.10.01)
Is it possible to output corresponding to the judgment display of the screen? (9)(2015.10.01)
When the CF-4500 has CF-0458 Power source backup function, is it ok to turn the main power immediately after the CF-4500 is started? (10)(2015.10.01)
When the panel condition is loaded, the Input relay set to main unit is cleared. Is it possible to save the setting condition of the Input relay to the panel condition? (11)(2015.10.01)
When the CF-4500 main unit is started, WAVE MODE is turned OFF. Is it possible to turn the WAVE MODE ON? (12)(2015.10.01)
Is it possible to manage data of several CF-4500s in one PC by the external control function? (13)(2015.10.01)
In which timing is the OUTPUT RELAY of [PANEL COND READ] to short-circuit and return to open? (14)(2015.10.01)
How many seconds is the power supply backup function necessary from turning off the power supply to the start next?(2015.01.05)
What do those colors of condition view mean in condition view?(2014.06.30)
Averaging signals occurring repeatedly several times and judging it from the result.(2014.06.30)
How to capture and analyze single-shot phenomenon which is incidentally occurred. (2014.02.03)
How to set and start 10 seconds of averaging processing with an external signal(2014.02.03)

Revised:2013/04/22


webinfo

© ONO SOKKI CO., LTD. 1996-2025 | Terms of use | Privacy policy