The signal from an accelerometer seems to break off. Sometimes disconnection is detected or there is no signal reception.

An application including an accelerometer and the NP-0021 miniature/BNC conversion connector may have bad connection because a rubber packing attached to the NP-0021 is too thick to connect firmly. Please use the NP-0021 without a rubber packing in that case. Insufficient tightening may cause poor contact.

 

Please make sure to remove a rubber packing before connection especially when used with the NP-3211.

Revised:2002/08/19


Copyright © ONO SOKKI CO.,LTD All Rights Reserved. | Terms of use | Privacy policy