How to change the measurement display time of the TS-2600

To change the measurement display time, use the REMOTE connector.

The measurement display time can be changed from 100 ms to 32 s.

To set the internal of measurement at every 0.1 s, input the following logic signal or non-voltage contact point to the connector pin (TRIG IN) between B and D.

 

* It is effective when the parameter settings from 1 to 7 of the TS-2600 are ON (EXT).

 

Revised:2002/03/15


© Copyright. ONO SOKKI CO., LTD. All Rights Reserved. | Terms of use | Privacy policy