What is the measurement range of the HT-3200?

The HT-3200 Handheld Digital Tachometer is used by pressing a switch to select the measurement range.

 

To change the measurement range, first press and hold the MEMORY/COND switch for 2 seconds or more. Then the measurement range setup mode is entered and the current measurement range appears in the MAIN display. Each time you press the MEMORY/ COND switch, the measurement range switches between "Hi" (high range) and "Lo" (low range). Select a target range.

 

 

 

Press the power switch to return to the measurement mode. The current display value is applied. If you perform no operation for 30 seconds in the setup mode, the display value immediately before turning OFF the power is applied.

 

Incidentally, when using the KS-200 Circumferential ring, it is necessary to multiply the displayed reading by 0.1 to get the actual measurement.

 

Ex.)
If the displayed reading is "123", the actual measurement would be "12.3 m/min".
If the displayed reading is "523", the actual measurement would be "52.3 m/min".
If the displayed reading is "12.3", the actual measurement would be "1.23 m/min".

Revised:2013/06/17


© Copyright. ONO SOKKI CO., LTD. All Rights Reserved. | Terms of use | Privacy policy