The VR-6100 Vibration Level Meter can print measurement data from the DPU-414 Thermal printer (separately sold) with the connection of dedicated AX-5042 connection cable. Either of normal print mode (normal print out) or automatic print mode (prints out the measurement data automatically and continuously of the memory data recall or timer measurement) is operated. In addition, please purchase the dedicated AC adapter which is separately sold, when the use of the DPU-414 Thermal printer. Please read through the operation manual which attaches to the DPU-414 before handling the unit.

 

 

Printer (DPU-414) connection method

 

Connect the RS-232C terminal of the VR-6100 Vibration Level Meter and the DPU-414 Thermal printer with dedicated AX-5042 connection cable.

 

 

Print the measurement data

 

When press the panel switch [PRINT] of the VR-6100, the printer starts to print the current measurement data. Also, press the panel switch [PRINT] for half seconds or more, to automatically print each measurement data during the recall of memory data or timer measurement. RS mark of the VR-6100 blinks during printing. If you want to stop the printing in the middle, please press the panel switch [PRINT] of the VR-6100 again.

 

 

 

Printing samples and printed items

The followings are the printing samples. Please note that the fonts which are used in the following samples are different from those actually used for printing.

 

 

 

Recommend setup example of the DPU-414 Thermal Printer